Results 1 to 3 of 3

Thread: BSOD 0x124 am out of options

  1. #1
    Join Date
    Oct 2009
    Posts
    2

    BSOD 0x124 am out of options

    Hey guys,

    Been spitting around alot of forums to try and solve my problem but still no luck.

    Maybe u guys can help me solve the problem.

    My setup:

    Case: HAF 922 With the standard 120mm fan at the back blowing out - 230 mm fan on top blowing out - 120mm in front blowing in- 2 x120 mm on the side blowing in.
    PSU: Antec 850 W
    Mobo: Asus p6t SE
    CPU: i7 920
    CPU-Cooler: Scythe mugen II With fan blowing towards the rear 120 mm fan
    6GB Tri-Kit OCZ 1600 8-8-8-24 1.65V
    2x HD4870 in Crossfire with ATI 9.9 driver (stock speed)
    1tb Sata HDD
    LG DVD RW
    --------------------------------------------------------
    -Builded the pc myself
    -First time i started up my pc..it didnt start.. came to notice i attached a psu cable from a different psu (old 650 w psu) to the 850w.. removed it.and the pc started.
    -Installed windows 7 7600 Plus ATI Driver 9.9 --> all ran fine.
    -flashed bios to 0603
    -Then id thought to try and o'clock my system --->Read some about overclocking in this guide:

    -3.2 Gig was stable in prime 95 for 45 mins..(in coretemp: cpu was 45 degrees celsius stressed- idle 35 degrees) then ive done the 3.8 part and pc shut down after 15 mins of prime95.
    After that pc stopped going to bios...everything turned on..but no beeps and no bios.
    removed battery. for half a day..set jumpers..removed 1 stick of memory..vid cards etc... no luck.
    Just after 2 days of no power to the pc the pc started again.

    -Reflashed bios to 0603
    -left everything at stock speed and auto
    -reinstalled windows 7
    -installed ati driver 9.9
    -ran prime 95.. after 20 mins.. bsod 0x124. dump file read..it said 0x124. internal hardware error
    - sometimes i can play a game or internet for like 2 hours..then it shuts down. again.

    I am now thinking either my powersupply is broken..cause of the wrongly inserted cable
    or its my cpu cause of the o;clock to 3.8
    But in my opinion its abit strange my cpu is the problem cause at 3.8 prime 95 my core temps were about 59 degrees stressed.

    Is there anyone that can help me out here?


    Many thanks in advance.


    -
    Last edited by Afzal; 20-10-2009 at 05:21 PM. Reason: external links not allowed

  2. #2
    Join Date
    Oct 2009
    Posts
    2

    Re: BSOD 0x124 am out of options

    Overclocked to 3.2 with these settings:

    Ai Overclock Tuner - Manual
    CPU Ratio Setting - Auto
    Intel (R) SpeedStep (TM) Tech - Enabled
    Intel (R) Turbo Mode Tech - Disabled
    BCLK Frequency - 160
    PCIE Fequency - 100
    DRAM Frequency - DDR3 - 1282MHz
    DRAM CAS# Latency - 8 DRAM Clock
    DRAM RAS# to CAS# Delay - 8 DRAM Clock
    DRAM RAS# PRE Time - 8 DRAM Clock
    DRAM RAS# ACT Time - 24 DRAM Clock
    CPU Voltage 1.10000v
    DRAM Bus Voltage - 1.66v
    Load-Line Calibration - Enabled


    and with 3.8 these settings:

    Ai Overclock Tuner - Manual
    CPU Ratio Setting - Auto
    Intel (R) SpeedStep (TM) Tech - Enabled
    Intel (R) Turbo Mode Tech - Enabled
    BCLK Frequency - 181
    PCIE Fequency - 100
    DRAM Frequency - DDR3 - 1451MHz
    DRAM CAS# Latency - 8 DRAM Clock
    DRAM RAS# to CAS# Delay - 8 DRAM Clock
    DRAM RAS# PRE Time - 8 DRAM Clock
    DRAM RAS# ACT Time - 24 DRAM Clock
    CPU Voltage 1.20000v
    DRAM Bus Voltage - 1.66v
    Load-Line Calibration - Enabled

  3. #3
    Join Date
    May 2008
    Posts
    666

    Re: BSOD 0x124 am out of options

    According to me you should turn on your computer and go into the BIOS. For more information, you can check out the following link. Then find the entries pertaining to your hard disk controllers (IDE and SATA), then if a settings is available to change, make sure that "32-bit Disk Access" is turned on for all controller ports. Hope so it may help you out.

Similar Threads

  1. Replies: 6
    Last Post: 05-08-2011, 10:33 PM
  2. Options after B.com in...
    By whatshouldido in forum Education Career and Job Discussions
    Replies: 1
    Last Post: 11-05-2011, 07:22 PM
  3. 9920G GPU Options ?
    By Atalaya in forum Monitor & Video Cards
    Replies: 4
    Last Post: 03-09-2010, 02:32 AM
  4. No UPS tab under power options.
    By Axtel in forum Windows XP Support
    Replies: 6
    Last Post: 08-04-2008, 02:41 AM
  5. Replies: 3
    Last Post: 29-01-2007, 08:59 AM

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Page generated in 1,711,638,207.43121 seconds with 16 queries