Nero 7 Update lead to Blue Screen in Windows

[Dharamsi]

hi there.......

This happened to me yesterday when I was installing all the updates after I install windows XP x64, put on some programs and everything was working fine. It all happened after I installed nero 7 ultra, then rebooted and couldn't get back into windows. This time, I did install nero 7 ultra and rebooted fine. So I turned my PC off. Next day when i turned on my Pc BAM, blue screen, no windows for me.. Yesterday I just did the repair install of windows but there is no scope for improvement.

It loads the Windows XP x64 edition screen, then goes black for a second, then about a milisecond of blue screen and then restarts.

I don't know what the hell is going on, I didn't change anything in the BIOS from last night when it was rebooting fine, now all of the sudden it's restarting again.

Please provide few reviews regarding this............

[Lillebror]

According to my opinion It May indicate a problem with the hard drive.
Try connecting another one, any drive, and see if it gets past that point.

[jesse]

you may require a bios flash ......

Download and install Everest Home Edition

Run the program, click + next to computer then summary

Look on the right for motherboard, then BIOS type

check the bios status and rest is what you will undertsand

[SalVatore]

Mostly such kind of cases occur when you download a corrupted driver and then driver corrupts your system files...........
it can be recovered by regedit....
try to check whether the downloaded file contains any malicious content or any virus and if it does remove it with the help of Regedit

[Dr. V]

Follow these instruction carefully:

1. Start the System Restore Utility at a command prompt
   
2. Restart your computer, and keep tapping F8 during the initial start-up until you get options, select Safe Mode with a Command Prompt then press enter.
   
3. Log on to your computer with an administrator account or with an account that has administrator credentials.
   
4. Type the following command at a command prompt, and then press ENTER:
5. %systemroot%\system32\restore\rstrui.exe
   
6. Follow the instructions that appear on the screen to restore your computer to an earlier state.