Results 1 to 5 of 5

Thread: How to test Radius authentication for DDWRT

  1. #1
    Join Date
    Feb 2012
    Posts
    64

    How to test Radius authentication for DDWRT

    Hello friends, I would like to test radius authentication for my DDWRT Linksys router and also wanted to test some of home radius routers also, so does anyone know anything about it then please share with me. I have tried to find out about it but did not got anything related to it, if you people does knows anything about DD-WRT then do share, as I will be able to get some idea about it. Thank you.

  2. #2
    Join Date
    Mar 2011
    Posts
    467

    Re: How to test Radius authentication for DDWRT

    I've been using Linksys WRT54G router WRT54G in a long time. I've updated the firmware. Buy it, but still too long so I'm thinking create a dependable brand. Of course, because the old model does not support N-mode has its drawbacks. WRT54G with DD-WRT is still a dependable pump where there was strong nuclear and wondered whether beyond. After successfully upgraded the firmware is less than one screen. I used firmware DD-WRT v24 sp2 (build 14896 2010/08/07) is Up from here before the contributions were. How to upgrade the firmware is the same. The article fails to report a firmware upgrade reply to Him, you've posted a firmware upgrade will require a lot of attention. The firmware upgrade is sensitive operations. In my case, this award 15 times, but also buying and never check error. Even for a short while after a connection is dropped during the upgrade to firmware because there will not be able to destroy. Also, you must use the firmware for the device. Hack the firmware upgrade did not blow the welcome from the manufacturer. Might have a problem from the manufacturer may refuse to AS I; l cannot guarantee for the firmware upgrade please note that.

  3. #3
    Join Date
    Mar 2011
    Posts
    443

    Re: How to test Radius authentication for DDWRT

    New site coming up in two WRT firmware for all firmware I cannot verify. Today I tried a direct verification for the model WRT54G V24_SP2 version. Select the appropriate firmware for your model if you have a problem which will not. I have verified that offering the firmware is shown in the screenshot below. Homepage comes up continues to upgrade the firmware probably. Eagle saw this when a firmware upgrade if you select other than the firmware is not whether I shall try not guarantee'd already ... In fact, experts also not uncommon for a firmware upgrade that inadvertently occur. Did you know? Yesterday I have network-related things, but now it did not touch a lot of equipment, donít take the risk of upgrading the firmware upgrade, the upgrade is always present and must be run directly.

  4. #4
    Join Date
    May 2011
    Posts
    460

    Re: How to test Radius authentication for DDWRT

    If you wanted to create a hotspot with My Wi-Fi service we need only a wireless router that has within it a hotspot with a RADIUS authentication module (e.g. Mikrotik router) or a wireless router on which you can install an alternative firmware (e.g. DD-WRT , CoovaAP , OpenWrt ) that supports RADIUS authentication. Fortunately, the majority of members of the routers on the market support almemo firmware DD-WRT. Even the 'OpenWRT is the widely supported but its installation is somewhat more complex. Finally, if you have Linksys 54GL, firmware CoovaAP is undoubtedly the best choice given the high stability of its form Hotspot RADIUS (CoovaChilli). If you do not already have a router, we recommend that you purchase from our site the Linksys 54GL. You will receive the firmware already pre-configured for use with My Wi-Fi Service. To set up your Hotspot will not have to do is connect to your modem.

  5. #5
    Join Date
    May 2011
    Posts
    428

    Re: How to test Radius authentication for DDWRT

    DD-RWT acts as a broadband router or wireless LAN firmware replacement for the existing wireless LAN access point, QoS capabilities and features to be available VPN, management SSH, Syslog, Samba, by SNMP, features Telnet, UPnP, VLAN, such as Wake On Lan is ridiculous now, that becomes possible, such as authentication, RADIUS WPA / TKIP, AES, WPA2 encryption also. In the country can be applied to the Buffalo and Linksys wireless LAN access point. No action is required has become so difficult to be able to control via the browser properly. Fairly easy since they are much the same as the normal procedure of a firmware update to install. Because they are also lists wireless LAN access points have been verified to work on, is not it also possible to make a wireless LAN access point equipped with the functionality of the class to several hundred dollars a wireless LAN access point of several thousand yen.

Similar Threads

  1. The Blast radius in Prototype 2 is quite small
    By BSOD.K in forum Video Games
    Replies: 1
    Last Post: 26-04-2012, 01:15 PM
  2. How to install ddwrt, or other firmware OpenWRT on La Fonera
    By Banned-BlackBadal in forum Networking & Security
    Replies: 3
    Last Post: 12-03-2011, 04:49 AM
  3. Windows Server 2008 NPS RADIUS
    By FFCookie in forum Operating Systems
    Replies: 5
    Last Post: 21-08-2010, 05:31 AM
  4. What is an Authentication Services - RADIUS in PHP?
    By Beter 2 Burn Out in forum Software Development
    Replies: 5
    Last Post: 06-03-2010, 11:59 PM
  5. Replies: 6
    Last Post: 20-06-2006, 07:20 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •