Need help with pvid on HP ProCurve 1800-24G

[Pette D Champ]

I have been using HP ProCurve 1800-24G and I have recently upgraded it to firmware version 3.02 and have also added some additional VLANs 1, 10, 20, 30, 40, 50, 255 respectively and I have also assigned port 19-24 to 255 and port 17 and 18 to VLAN 50 and have removed the 28-24 from VLAN 1 and now the problem is that I am just able to chose PVID "1" on the "Port configuration" site for port 17 even after being member of 1 and 50 and I am not able to chose any from the port 18, I have been trying to reboot the machine but then it is not making any difference is there any other solution that I can try out???

[Reese-R]

I have been using HP ProCurve 1800-24G and I have recently upgraded it to firmware version 3.02 and have also added some additional VLANs 1, 10, 20, 30, 40, 50, 255 respectively and I have also assigned port 19-24 to 255 and port 17 and 18 to VLAN 50 and have removed the 28-24 from VLAN 1 and now the problem is that I am just able to chose PVID "1" on the "Port configuration" site for port 17 even after being member of 1 and 50 and I am not able to chose any from the port 18, I have been trying to reboot the machine but then it is not making any difference is there any other solution that I can try out???

I will suggest you to better post here a copy of your Config so I can check out the same and have a better idea of the setup that you are having , just attach it here for further help.

[Pette D Champ]

I just wanted to share that I am not having the CLI "installed" and I have not yet used as well, anyways I have attached the Screenshots of the Browser page jus check the same out and see if you could help me, I also wanted to know if it will be possible for me to access the CLI like SSH or not, if yes than how, any further help for the same will be highly appreciated.

[Rance]

As far as I am aware you can just Telnet into the switch and use the IP Address that is used to access the web browser on 192.168.2.10, here I will like to inform you that by default SSH will be disabled but then you can still access a CLI as it will be available on the port 23. Hope that helps.

[Pette D Champ]

I have been trying out to telnet with putty and windows "native" telnet but then I have not yet got any luck and it has been some weeks, I don’t remember the exact error but then it was something saying "connection failed", I just wanted to confirm if you are quite sure if the 1800 series is having a telnet/ssh interface, I mean I have checked out for the same but then I am not able to get anything in the manual. Why is it so? Do you have an idea about the same???