Engenius ECB3500 keeps dropping wireless

[Xymaya]

I own an Engenius ECB3500 that was effectively ported on the way to DDWRT. The whole thing is running vast by means of the firmware; however the just trouble is the wireless seems on the way to be dropping. I have attempted changing channels, no dissimilarity. Each wireless client would be associated on the way to it with no problem, however subsequent to a few seconds they would be dropped as well as after that connections start again in 10-20 seconds. My doubt is that several wireless settings are not correct. Please have a seem as well as offer feedback. Thank you in advance.

[Amie]

We have premeditated a free of charge configuration as well as a reset program by means of the Boating as well as RV community in brain. This free software is offered AS IS however please make use of this thread on the way to offer feedback. You can download the software engenius_network_configuration_software easily from internet.

[Gaia]

I'm also having problem resetting my EOC-3220 by means of your 3220reset utility, possibly you have any advice on what I may possibly attempt.
This is my situation:
Laptop (192.168.1.X) -> Router (192.168.1.X) -> EOC-3220 (10.10.10.10)
I primary set my local ip on the way to 10.10.10.15, subnet 255.255.255.0 as well as default gateway 10.10.10.10 as well as attempt on the way to arrive at the 3220 webinterface. I after that start up 3220reset.exe as well as enter the 10.10.10.10 address. The program idles for about 10 seconds furthermore after that returns on the way to the command prompt. Afterwards on the other hand, the 3220 is at a standstill at 10.10.10.10 as well as I cannot login on the way to the webinterface by means of the default credentials. I suppose a soft reset would as well have on the way to set the 3220 ip back to the 192.168.1 range? Any suggestions? Thanks for your help!

[HiSpeed]

The reset program make use of the snmp utility of the bridge if it was disabled or else the community strings misrepresented you will have on the way to make use of the console cable to reset . If this does not resolve your issue then you be able to as well attempt the getif program. However this program as well make use of snmp.

[BiGMaCHiNe]

I have presently accomplished finishing resetting my EnGenius 3220 Access Point Client Bridge, by means of the commands offered on the Keenan Systems LLC site. I did receive one more step. Subsequent to the DOS window closed, I disconnected the Ethernet Cable as well as after that reattached it, stopped up plus reopened the web Interface (IE7), enter the IP Address of 192.168.1.1 and wallah, all was reset to factory defaults...Thanks, saved me the cost of a bucket truck or else a drop from a ladder.