How to setup 7804WBRA SMC Barricade Router

[Mahish]

Hi buddies,

Yesterday I had purchased a 7804WBRA SMC Barricade Router.It is becoming less frequently used for an ADSL modems, and I found it is complex devices to use and configure, but at the same time offer a wide range of possibilities in terms of connection capabilities. I need some helps regarding the installation procedure 7804WBRA SMC Barricade Router. Please suggest.

[Milton.J]

These router identified by the word "router, enable connection of multiple computers by mounting small local networks, while a limited number of machines connected to the network, the number of connectors or" mouths "ethernet available.These devices give us the possibility to use new wireless communications technologies, expanding the number of computers connected to the network significantly. check that and reply.

[Spyrus]

First you need to check to see if there are all the elements necessary to operate the router, that is, the device itself, the power adapter to provide power, a four-wire telephone cable with RJ11 connectors that allow us to connect the router to rosette and at least one telephone twisted pair cable with RJ45 connectors, we can connect the PC to the router. You will pick up the phone cable and connect one end to the wall the phone or in one of the sockets RJ11 Connector T socket and the other end to the router.You will take the network cable and connect one end to the Ethernet jack on your PC and the other end to one of the connectors on the router. Check that and reply.

[Snake08]

There are two ways to configure the computer, the first through the program that provides the connection provider and the second is directly entering the program has default settings that the router and accessed through any browser. You should use the program Internet Explorer to access the setup program and will allow us to access all the settings with ease because the router itself has a small web server that will allow us to access all options configuration. Best of luck.

[Zachary]

To enter the setup program simply type in the address bar of Internet Explorer IP address of the router, keep in mind that the address is 192.168.1.1 if the router is new or has not changed this address in a previous settings, if we changed the IP address should be the appropriate type. It's important to make the configuration of the router using wired connection, in many cases the wireless network is disabled by default, and if we change any parameter related to the wireless configuration we may lose the connection to the router via wireless card. Check this setting and reply.

[Big Fish]

If you have configured the system to have a password, you must enter the password and click on the button 'Login', should be the first time you access the router we need to introduce smcadmin in the password field and click on the button 'Login'. Advanced Setup where you should set the parameters for overall system configuration, including password change, firmware upgrade, set time zone, etc and you also have the manual settings with the following: WAN, LAN, wireless, NAT, firewall, router, QoS and ADVANCED. Best of luck.