How to setup Westell 6100 bridge linux router

[AK_Chopra]

Recently i had bought a new Westell 6100 bridge linux router for my system. I would like to know that how do i setup Westell 6100 bridge linux router for my system? Does any body knows about it? Kindly provide me the correct solution for the above issue. Would be grateful to you if any body provides me the correct solution for the above issue.

[Milton.J]

For that you need to first connect your computer to router and then try to login to web interface of router and change the lan ip of router as 192.168.10.1 with start ip as 192.168.10.2 & end ip as 192.168.10.51. Then you need to connect your modem to router and check out the ip address on your computer and then try to logging on your router using the new ip and then configure the router.

[Spyrus]

First of all verify that your NIC card is been set to "Obtain IP Address Automatically". Completely power down the Westell and the computer(s). Then you need to power up the modem and then need to press the reset button on the back of the modem for 10 seconds. After the modem has fully reinitialized connect the Westell to the NIC and then power up your system Then you need to open up any browser application and then need to enter 192.168.1.254 on the URL address field in order to access the Westell interface. If you are unable to access the interface then try to make sure that your NIC is set to "Obtain an IP address automatically". If that is set correctly and you still can not connect to the Westell interface, reboot the computer (or release/renew) to obtain a new IP.

[Snake08]

If you still can't setup your new Westell 6100 bridge linux router, then it highly recommended that that you contact your service provider or manufacturer in order to get technical assistant in order to resolve the above issue.