Problem with my D-link router di604

[Beter 2 Burn Out]

Hi!

I bought a dlink router di-604 to share my Internet connection ,first time I installed it worked correctly, I easily reached the administration interface (http:192.168.0.1) . By against I had a concern and I wanted to do a reset because I gained more in the admin interface. I followed the letter of the reset procedure but there is no change. Do you know how to reset the router? Does this can be a hardware failure?
Thank you

[Snake08]

The IP address that you have is an automatic IP address the Windows generates. It basically means your computer is not getting an IP address from the router (DHCP). You should try powering everything off. Then, in this order, power on your modem, wait 30 seconds, then, power on your router, wait 30 seconds, then power on your computers...This should fix the problem since one computer is working already.

[Steve123]

There is a small pinhole on the back of the router near the power connection. To reset the router to all its factory defaults (including resetting the admin password) make sure the router is ON (the power light is on) and, using a paper clip, push the tiny button inside the pinhole for about 10 seconds. Then, when you log into the router, the user id will be admin and there will be NO password. Just hit return. That should do it. I strongly recommend setting a new password immediately.

[Milton.J]

Here is the procedure to do a complete reset on the di-604, you must:

• Router start (LED "power" and "status" lit)
• Press the reset button and hold for the rest of the manipulations.
• Unplug all cables LAN, WAN and power supply (supplies last)
• Stay another 20 seconds holding the reset button.
• Reconnect all.

And normally it should work