Problem with Packet Scheduler Miniport

[Dharamsi]

hello there

I noticed in Device Manager that for each interface, their is an accompanying "Packet Scheduler Miniport," but i have the yellow exclamation point next to them. After Double clicking and saw "Windows cannot initialize the device driver for this hardware (Code 37)." I have also tried uninstalling the entire network devices and reboot again, but I mess up at the same point every time after reboot.


Please help me with this problem
your views will be appreciated

[Milton.J]

Looks like your app may have accidentally gotten attached to a master sync app that you don't have access to, or that was deleted. Rt-click your project and from the IPP tools menu choose "Remove Master Sync App Binding

[Spyrus]

This code means that the system has not had a chance to configure the device. To resolve the problem, follow the instructions in the Device Status box. In addition, you may be able to resolve this issue by removing the device in Device Manager, and then running the Add New Hardware wizard from Control Panel.

[Snake08]

Depending on which device is failing, you may see either of two different messages. This code means that the device loader (DevLoader) did not load a device. When this device is a Root Bus DevLoader (for example, ISAPNP, PCI, or BIOS), the following message is displayed
Windows could not load the driver for this device because the computer is reporting two <type> bus types. (Code 2)

Contact your computer manufacturer to get an updated BIOS for your computer.

Where <type> is ISAPNP, PCI, BIOS, EISA, or ACPI.

Solution button: None
When the device is not a root bus DevLoader, the following message is displayed
The <type> device loader(s) for this device could not load the device driver. (Code 2)

To fix this, click Update Driver to update the device driver.

Where <type> is the DevLoader such as FLOP, ESDI, SCSI, and so on.

Solution button: Update Driver
In addition to following the recommended solution, try removing the device from Device Manager, and then running the Add New Hardware wizard.

[Zachary]

Windows cannot install the drivers for this device because it cannot access the drive or network location that has the setup files on it. (Code 32)

To fix this problem, click Restart Computer to restart your computer. If that doesn't work copy all the setup files onto your local hard disk, and run setup from there.
Solution button: Restart Computer

This code indicates that the installation disk or CD-ROM was not available to install the drivers. For example, the CD-ROM drive or network connection is not available. This error typically occurs during the first or second reboot after all the files are copied during Setup.

To resolve this issue, first attempt to restart as suggested. If this does not resolve the problem, determine why the installation disk or CD-ROM is not available. Typically, these devices also have Device Manager codes (such as the CD-ROM controller or network adapter). Resolve the issue to gain access to the installation disk or CD-ROM prior to resolving this conflict.