Unable to boot with double sided value of Corsair VS512MB400

**Hasrat$** · 03-10-2011

My motherboard is DFI Lanparty NF4 ultra-d and currently runs on 1 (one) cartridge corsair value of 512 MB of RAM on one side. Both the Committee cannot detect and double sided sticks are dead and I RMA. Or should I adjust some BIOS settings? Could it be that I'm doing something wrong.

**Battista** · 03-10-2011

With only one of the new modules installed I would try and remove the battery power and clean the plate and BIOS. There should be a bridge to force a restart of the BIOS and see if they can publish.

**Martyna** · 03-10-2011

I did what I supposed - cleared CMOS with a double-sided stick - and started again! I went to the BIOS to disable the logo screen, push F10 (save and exit), and never restarts.

Diagnostic indicators are stuck in 3 red leds.Should I adjust something in the BIOS to allow the RAM to boot normally? As voltage or incredible. Or maybe all peripherals disconnected? When I get back the fix on one side, the ram voltage to 2.6V was again, despite the fact that I had put it back to 2.5v before clearing the CMOS.

**Pamina** · 03-10-2011

Attempt to do the identical, nevertheless adjust the voltage to 2.6 or even 2.7.i had a pair that had to run at 2.8 i overclocking and they were fine.

**LavinaD** · 03-10-2011

Ok, I did a lot of clearing CMOS and frequency of replacement, and finally reached an acceptable configuration you are starting at 333 MHz sticks 2T

The tension adjustment does no good in the end, is a kind of self-adjustment (currently is set at 2.6V voltage sensors, but show that a stick runs at 2.55v, and when thrown together 2.76v) . So the whole trouble was the frequency - the club cannot run in your car speed SPD (which is 200 buses) in my system, for some cause, and unaccompanied or mutually cannot go beyond 166.

**ADELYN** · 03-10-2011

VS512MB400 - I've also been running my Corsair 512Mb DDR400 double sided DDR333 Value Select speeds on a nForce2 motherboard (Epox 8RGA +), has for5 years and so far is functioning extremely well. I could not actually test my module is running at DDR400 speeds VS512Mb400, despite the fact that (Board or curb of the processor in matter)