I have a strange problem since yesterday. I changed the DDR2 memory on my Asus board and wanted to restart. But then there was only a black screen and beeping from the case. 1 long and two short times in the loop. I wanted to install the old memory module again to eliminate the problem, but it remained up to the beep. I already switched power supply, video card, CPU / fan, monitor out and tried separately from the old DDR2 memory on one of Simms. I did that with the new memory. So, each equipped with a bank and the series. Then I did CMOS reset (battery previously taken out) and also changed the battery. All brought no success. My friend suggested that you should disconnect all (IDE, SATA devices, memory) and reboot the system with the CPU. And something amazing happened to me. No matter what I put into the system and how I tried to boot, the beeping sound (long, short, short) did not change. Whether with just the CPU or memory. Now my question: What can I do? The bios may crashed or at a motherboard fault? The capacitors at any rate still good. Is there any solution for the problem?
Bookmarks