3d Stereo with planar system

**Talishh** · 27-09-2010

I am having FX 4500 card and a planar SD2020 Stereo display but it does not work. I have installed the latest driver 169.47 but is still not working. Stereo mode is active, monitors are in clone mode. I have tried the older version of driver 91.36 but still same problem. Does any one else is having the same issue and if you have any solution to solve it please inform me. Thank you in advance.

**Archibald** · 27-09-2010

I have solution to your problem, even i am using FX4600 and have the same issue.In the base settings of your workstation, Please do not forget to set monitor below planarsystem as PRIMARY. This will enable you to set the stereo mode within the setting of quadro FX 4500 card on nView Clonemodus. Hope this will help you to set your 3D stereo with planar system.

**David23** · 27-09-2010

I can't understand this issue. I am having SD26 with NVIDIA quadro fx4800 on my windows 7 64 bit. I am confused with planar setup. Whenever i boot up my system every time i need to set the clone mode. And sometime when i went to "nvidia setup for multiple display" for clone mode. The clone option sometime disappear in next minute. I check the cable but the cables are correct. Does any one can help me to get rid with this fatal problem. Your effort will be appreciated.

**Birdie** · 27-09-2010

This type of problem are mostly due to the driver. Try to get the driver which is compatible with your syatem.To use your SD2020 device you need to download a proper Planar driver and extract it. You can go to below link to get driver.
http://apps.planar.com/downloads/
Get the right driver install the driver, reboot the system.If you need you may change hardware parameters in a program interface.See now it may work fine.