BD-4600 flicker problems

[Character]

Hi all,

I have a Samsung LCD TV and have complained about their sets turning off for no reason. It is a programming fault from the factory that causes the TV to turn off at convinced times. Screen is also fluctuate. Please suggest. Thanks in advance.

[Marthaz]

Some times experimental use is you LCD TV is harmful, because DVD video signal output is wired to provide the RF signals, Samsung, from sales to after-sales service are the worst and sales personnel commitment is Samsung screen is a fake from the monitor to the Samsung LCD TV, the highest failure rate, the worst quality of service, would like to purchase LCD TV's friends must have to choose the right brand, avoid Samsung products to bring you troubles. Check and reply.

[David23]

You should be using the Samsung panel, so there Toshiba door event, Samsung TV is also basically in 3 months or 6 months, problems arise, consumers can find co-processing, LCD TV Warranty 3 years, some of the provisions of 1-year warranty, is illegal in the state have imposed the warranty terms, you can now consult consumer association and manufacturers in the defense arguments. Check and reply.

[Archibald]

You need to switching power supply on the fact that there are now hot plate and cold plate problem (commonly known) power switching power supply in the initial stage there is no separation between the (use of hand-touch power sub-section may result in electric shock) cold plate power supply first-class physical isolation.Therefore, using hot plate power supply may cause problems.

[ApPy10]

This is usually a video data transmission problem. Classically data transmission problems with HDMI are cable related. It might be that the cable is under performing owing to its length. This is especially normal with cheap cables. Remember the HDMI spec says cable length should not surpass 10 meters. limitation the cable should get better the signal truth. Another option in this circumstances is a bad connector. HDMI connectors are disreputably fickle anyway. Attempt a new cable at each position down the signal path. Check and reply.