Seagate seatools 1.2.0.4 shows more than 1 hard drive

[$ingham]

Sponsored Links

I am using Windows7 x64 on my system and have comprised an old ST330083A mounted in a detachable drive tray which was having tribulations through extremely long verifies commencing from side to side Acronis TI 2010. Installed Seatools for Windows 1.2.0.4 and it demonstrates two ST330083A drives through the identical serial. When in fact the system merely has one of the drives installed. Where is the 2nd hard drive coming from. I even went to the tremendous of eliminating the partitions on the hard drive without any effect.

[Gameli]

Additional than you be able to uninstall SeaTools for Windows, reboot, then try the entire in excess off again. You be able to utilize SeaTools for DOS. In addition, when you say it's in a detachable drive tray, what is the cable/interface by which the drive is connecting to the motherboard.

[Dannai7]

I have encompassed a brand innovative Seagate 2TB ST2000DL003 installed as my main backup drive. It is in a drive inclusion that to facilitate fits + connects to a drive tray associated to the motherboard by SATA cable. Initially when I endeavor to copy a large (17GB) file commencing from the disk, I continuously acquire an Error 0x8007045D. I installed Seatools 1.2.0.4 to make sure the drive other than it recognizes each drive in my system twice containing an intel SSD, a WD raptor and WD 1TB eco green drive.

[JErastus]

I do not be familiar with the whether to select just presently 1 of the 2 Seagate drives or both. I had attempting uninstalling Seatools, rebooting and reinstalling (fresh download too) other than the predicament persists. And I did not have several other programs working with not even virus scanner. Using Windows 7 x64 bit tranquil not even certain if this program supports 64 bit having read additional threads it is extremely disappointing Seagate.

[Faiyaz9]

I desired to acquire your innovative 2TB for the reason that of the 4k alignment characteristic and some minor issues through the WD 2TB equivalent other than I am having doubts at present as to whether I made the right choice. I determine to try connecting unswervingly (i.e. not via the enclosure) as that seems similar to it might be an issue.

[ErikaGeek]

I am working with Windows 7 Ultimate on an Intel x58 chipset utilizing AHCI built-in Window AHCI drivers and I am experiencing accurately the similar predicament other than for me SeaTools duplicates each hard drive and SSD installed! In view of the fact that this aberration creates me unsure of what's going on or what determine to happen if I prefer any drive, this makes Seatools helpless.

[phunsuk]

I am also having the similar problem. Every disk is show two times in SeaTools. When I add an innovative external sata drive via my e-sata port, that with the intention of new drive is in addition duplicated as well. I be able to tranquil run the test on moreover drive it seems, other than is the test accurate at present through this behavior. You just presently have to pick one does not matter and you be able to test away. I was capable to test a small number of dozen drives last night. I had sent the bad one to the service centre.

[Saddys]

I have 1.2.0.5 and it is even of inferior quality if you have additional drives attached. I have comprised 7 internal drives and 5 external attached. As you be able to observe the external drives are imperceptible due to the numerous duplicates displayed commencing from the internals. In this case Seagate hold up asked me to unplug the externals and install them on the inside. I am actually lost. The 12 Seagate drives on a system and with the intention of unprofessional reply. Anyone have encompassed a tool which be able to read out type and serial number of the external drives.