How to aggregate HP A5500-48G EI IRF port

[The$Adjuster]

Hello friends, I am having two A5500-48G EI switches which need to stack and also using two-port 10G modules and CX4 cables and have enabled the IRF on it. It is working fine for me when I am using the one connection between the switches only. When I am connect the second CX4 cable then nothing works. I wanted to aggregate two physical ports for each irf-port. Where the master switch 10G module is at module position 1, physical ports 1 and 2 are dedicated to irf-port 1; slave 10G module is at positon 2, physical ports 3 and 4 are dedicated to irf-port 2. If I connect any one cable between the irf-ports then it work fine, if connect both then it does not work. I believe that it will be configure, so please tell me, thank you.

[Amadou]

I wanted to know the configuration which is present on your switches, so if you provide that then I will be able to tell that what to do it. So just check and tell that what you can do it.

[The$Adjuster]

If you wanted to know about the configuration then it as below and even have the irf topology of it, so you better check it.

Configuration file
irf topology

[Dabert]

I think that you are having the following irf topology

irf member 1 irf-port 1 port 2
irf member 2 irf-port 2 port 4

You should able to list both of the physical ports as each virtual irf-port, just check the following method,

irf member 1 irf-port 1 port 1 2
irf member 2 irf-port 2 port 3 4

[The$Adjuster]

I think I need to enter the following commands for aggregation of the both ports, which might be able to work for me, so should I try or not?

irf member 1 irf-port 1 port 1
irf member 1 irf-port 1 port 2