Hp Printer Error 0xc18a0301 ink system failure

[Michael25]

Hi

I have a hp psc 2410 printer. I can no longer print, I have a message error "0xc18a0301 ink system failure" since that I've changed an ink cartridge when the printer asked. Can you help me solve this problem? Thank you in advance.

[SreeKanth]

Hp psc 2410 printer comes with the nozzles mounted on the system, not the cartridge as usual, is important in order to make a maintenance service to fix the printer before this issue logically, now well on their responsibility, if they do such maintenance printer can experience a more severe failure.
so clean once it solves

1 - turn off the printer
2 - press the buttons, OK, Cancel and Black (both)
3 - while holding these buttons pressed, turn on the printer.
4 - Once turned on don't release the buttons, you must wait until the screen goes black (in fact the printer is turned off), once you drop them off.
5 - Set time and date you turn and so on. etc. etc.

[HellBoy21]

Try the following steps to resolve your problem :

* Turn the printer.
* Once it is ready, hold down the key "9" and "#".
* Unplug the power cable and hold buttons
* Wait thirty seconds
* Reconnect the power, without ever having released the keys
* Wait until the logo "HP" on the screen turns off
* Release the 2 buttons
* Turn the printer via the button to activate
* Re-enter the language and other parameters
* Wait until the printer face maintenance (approximately 5 minutes)
* The printer is now ready.

[Pyrotechnic]

In the above steps told by HellBoy21 doesn't help them try the following, to resolve Hp Printer Error code 0xc18a0301 :

* Unplug the printer making the
* Simultaneously press the buttons "Cancel" and "ok" for 1 minute
* Reconnect the power of the printer
* Turn the button with "start"
* Press the button "Cancel" to turn off the printer.
* Restart with the button "Enable".

[Kirmiac]

Try Repairing of ink Hp cartridges

1. uncover the cartridge taking care not to break it
2. remove the cartridge and wash sponges
3. let stand overnight cartridge without sponges in a container of alcohol (not ruined I already did)
4. wash the next day with plenty of water (only water). at the base where the sponges were
5. throw water pressure
6. the cartridge and allow to dry sponge
7. reassemble the cartridge hits the top place if you like or tape
8. ink refills and ready

Now you can enjoy another long period of printing with your cartridge repaired. Try it. if it works and do not need to buy another,

[Salome]

To fix it, inject it obviously already know. Then, after injection of 3 ml each color (Cyan-Magenta-Yellow), the magenta cartridge is not ejected. Then we will perform the following steps:

1. Put the cartridge heads on absorbent paper until you stain.
2. Remove the brand label and number (if it is set) and blow hard putting in cartridge again in the absorbent paper.
3. When you see that makes a great spot, it's time to stop blowing, and pass the paper vertically, from top to bottom (for heads) several times.
4. Then we'll drive to the printer, and just in case, we will clean the printer software, and we will go to Word to create a document written in different colors (yellow, orange, red, green, green, etc.) naming each word with its corresponding color. This will prove the colors to text. Then go to Paint or any image editor and drawing pictures or lines, with the same colors. Print about 3 copies of each test.

If now the ink comes out correctly, the problem is solved!