After changing the black ink cartridge i printed some papers after that i get an error message ERROR 5700 in Canon PIXMA iP3000 . Is there any problem in Canon PIXMA iP3000 printer ? Is anyone know solution for this ?
Thanks in advance
After changing the black ink cartridge i printed some papers after that i get an error message ERROR 5700 in Canon PIXMA iP3000 . Is there any problem in Canon PIXMA iP3000 printer ? Is anyone know solution for this ?
Thanks in advance
Remove the head, then wait for 30 minutes in distilled water lukewarm. Then dry by shaking heavily and using kitchen paper. It working my friend did this.
Follow the steps to solve the Canon PIXMA iP3000 printer error 5700
- Start with the power off
- Hold down the ON / OFF button plus the RESUME button at the same time.
- Keep your fingers on both bottone and THEN let go of the resume button.
- Then press the resume button twice
- And then let go of the OFF / ON button (which you have been helding down while pressing the resume button twice).
- Then, first press and release the resume button 4 times
- And then the power button 2 times after this.
- The printer should now be okay and the lights will return to normal (solid green only).
Remove the Left and Right Covers and the Main Case Unit (main cover).
Remove the 4 mounting screws from the Chassis.
Remove the Main Unit from the Bottom Case.
Turn the Main Unit over (upside down) and place on work surface.
Inspect the ASF section of the Main Unit for a gap between the white plastic
guide and the Chassis.
The size of the gap varies. Even if the gap is not visible,
complete the steps below.
Disconnect the appropriate cables and remove the Logic Board from the
Chassis.
Loosen (do not remove) the 4 mounting screws (the mounting screws can be
found behind the logic board) on the Chassis.
Re-seat the white plastic guide so it sits flush against the Chassis. The
tip of the white plastic guide should sit slightly inside the
Mounting screw hole. When seated correctly, the gap will no longer be
resent.
Tighten the 4 mounting screws without causing the plastic guide to shift.
Reassemble the printer and retest.
Bookmarks